Obi200 - How to Enable Web Management Access
gelcom:
Guys, I'm having a hard time to enable Obi200 web access. I tried 2 options:
IVR:
I dialed ***0
Then when I dial 30# I get the message: Invalid option.
When I try to access my Obi200 ip address I get the browser redirected to:
http://obi200ip/servlet?p=login&q=loginForm&jumpto=status
then the website displays:
The requested URL was not found!
How can I access the web access??
Please note I have an Obi200, not an Obi202.
kind regards
Gustavo
zorlac:
I'd do a factory reset (***8 ) and then follow the instructions on this page after your Obi200 is hooked up to your router.
azrobert:
If you are trying to access the configuration pages via the local Web interface, type the IP address of the OBi200 into a computer browser and hit Enter.
The UserID and default password are both "admin".
To check if you have the correct IP address dial ***1
If you want to configure the OBi200 this way, you must disable Auto-Provisioning.
If you don't OBiTalk will overlay any changes you make.
System Management -> Auto Provisioning
Under OBiTalk Provisioning
Method: Disabled
gelcom:
Quote from: zorlac on December 26, 2014, 06:24:33 pm
I'd do a factory reset (***8 ) and then follow the instructions on this page after your Obi200 is hooked up to your router.
I've just did a factory reset but I don't want to configure the Obi200 through Obi website as I understand it's a risk to security to allow a website to access my device. I do want to configure it from the local web management utility....
gelcom:
Quote from: azrobert on December 26, 2014, 07:43:45 pm
If you are trying to access the configuration pages via the local Web interface, type the IP address of the OBi200 into a computer browser and hit Enter.
When I try to access my Obi200's ip address I get the browser redirected to:
http://obi200ip/servlet?p=login&q=loginForm&jumpto=status
then the website displays:
The requested URL was not found!
I'm still stuck in this....
Navigation
[0] Message Index
[#] Next page