Call Forward (unconditional) & dialling out on Obitalk 200 ---Help needed.
realjohny:
Quote from: azrobert on January 06, 2015, 02:10:20 pm
All the trunks have the same options.
Do the same as the Line port for each trunk.
They are found at:
Voice Services -> SP1 thru SP4 Service
I did it for SP1 (considering it is GV probably ?). Please see image below, I called my GV number but call doesn't go on my forwarding number via Bluetooth mobile. In fact it keeps ringing and finally goes to voice mail.
drgeoff:
Does the call actually reach your OBi? Check in the Call History. That is under Status in the local web interface.
realjohny:
Actually my DECT cordless was in energy saving mode & wasn't ringing for some time, but on direct calls on GV it rings immediately.
For diverting GV calls to my GSM number via a Bluetooth paired phone I have entered settings as you advised but calls are still ringing on cordless attached with ObiTalk with caller ID showing forwarding number. Can you advise what might be the issue?
azrobert:
Try a different method.
Set CallForwardUnconditionalEnable and CallForwardUnconditionalNumber back to default.
On the same configuration page for SP1:
X_InboundCallRoute: bt1(0657567588)
realjohny:
Actually without any forwarding GV rings on ObiTalk but with even last forwarding method it doesn't work :(
Navigation
[0] Message Index
[#] Next page
[*] Previous page