Freephoneline SIP with Obi200
drgeoff:
Quote from: atsn714 on January 27, 2015, 12:32:27 pm
2) let me clarify, I am not getting a dial tone after I enter **2 to pick my SP2 (FPL) line for outgoing calls.
That is normal. Continue dialling the rest of the number. What happens?
It is not like dialling 9 on a PBX and getting dial tone from an outside line.
(Most phones work fine with the default RingFrequency and RingVoltage. Nothing to do with the Service Provider. FPL are off-beam if they are suggesting those settings must be changed for their SIP accounts.)
corporate_gadfly:
Quote from: atsn714 on January 27, 2015, 12:32:27 pm
1) I am following the SIP account setup that was provided to me by FPL which has different settings for the Ring Freq and Ring Voltage than the default settings.
I briefly skimmed the post, so forgive me if I miss any minute details. However, for FPL SIP settings, the only two non-default settings for me are ProxyServer (voip.freephoneline.ca) and RegistrationPeriod (180 - you can try 3600 if you want as specified by FPL).
Everything else is on default settings and it "just works". I have a OBi202 (similar to your OBi200).
Hope that helps.
See screenshot
atsn714:
When I used **2 then followed by the nine digit phone number, the call would not go through. The phone does not provide a dial tone, busy signal or any signs of connecting.
BTW, I have deleted both of my SP1 and SP2 setups. With my FPL login credentials set up for SP1 this time, my Obi Dashboard status is showing Registered and not Connected as it did for GV. It seems that FPL is not connecting to OBI200 properly.
drgeoff:
Quote from: atsn714 on January 27, 2015, 01:12:21 pm
With my FPL login credentials set up for SP1 this time, my Obi Dashboard status is showing Registered and not Connected as it did for GV.
That is also correct. GV shows as "Connected" but SIP SPs show as "Registered".
You won't get another dial tone after you start dialling. That is normal.
Point your browser at your OBi's IP address. Log in with admin and admin. Click on Status. Click on Call History. Can you see any details of the call you tried to make?
atsn714:
corporate_gadfly,
Thanks for the screen shot. I noticed that on my setup, after ProxyServer Value, there is a red exclamation mark as well as after Registration Period and Register Retry Interval. Is the red exclamation mark showing that the entry is incorrect?
Navigation
[0] Message Index
[#] Next page
[*] Previous page