Google Voice SP1 Stuck on "Configuring..."
lrosenman:
Not any more with the latest firmware. You NEED to use the ObiTalk portal to configure Google Voice. They are now using OAuth2, which is MUCH more secure and GOOGLE APPROVED.
tpir72:
So do I need to turn on Oauh2 in that gmail account for GV to work with Obi202?
lrosenman:
No, just use the ObiTalk portal to configure the Google Voice SP.
SteveInWA:
See my complete instructions here:
http://www.obitalk.com/forum/index.php?topic=8560.msg56460#msg56460
This assumes that you have already set up a full-function Google Voice account, meaning, you have a Google Voice telephone number, which forwards to a verified forwarding telephone number in the USA.
If you can't get it to work, then you have probably made some non-standard configuration of your device on your network. You should be able to use a factory-fresh/reset, updated OBi, plug it in, add it to your OBiTALK portal account, log into the Google account that holds the GV phone number, in another browser tab, and it will simply work.
If it doesn't work, post your current location, and post a screenshot of this page, with all private information blocked out: https://www.google.com/voice#phones
tpir72:
Ok, so originally all I did was factory reset defaults on the voice portion of the OBI202. Out of final frustration, I factory reset the whole unit using the pinhole under it and GV configuration worked!
Now my problem is getting Anveo E911 service status changed from Service Not Configured to it properly setup.
I used the built in wizard to setup Obi202's E911 on Anveo but I'm still getting the message "Service Not Configured"...
Thoughts???
Regards,
Terry
Navigation
[0] Message Index
[#] Next page
[*] Previous page