OBi508 and hunting to old Avaya PBX

(1/1)

tellermetrix:
I have configured this device with Callcentric. Inbound and outbound calls are working. I'll be connecting the obi508 to an old Avaya PBX phone system with 6 to 8 lines(channels) in use. In order for the obi508 to work with the PBX I need it to hunt on each phone port instead of ringing on all the phone ports at the same time on inbound calls.

For example Port 1 and 2 are available (not in use), ring on port 1 only. If port 1 is in use ring on port 2 next.

In my OBihai configuration screen I see Hunt Groups Settings. But I haven't been able to find any documentation on it. 

Is there anyway to configure an Obihai device to work like this?



Thank you for your assistance.

Tuan:
Under Hung Groups Settings, on Group1, uncheck Obitalk settings and device defaults.  Type gp(1)={ph1+ph2+ph3+ph4+ph5+ph6+ph7+ph8};du10;np=0

Then under SP1, X_InboundCallRoute, uncheck Obitalk settings and device defaults, erase {ph1} and type gp(1)

Don't forget to click Submit for both changes to save settings.

This should activate hunt group.  (e.g. If line 1 is busy, line 2 rings, if lines 1,2 are busy, line 3 rings, and so on.)

tellermetrix:
That is awesome. I knew it was doable but could not find any information on it and thank you for posting.

Unfortunately we've decided to go with a different VoIP provider and won't be using it.

Anyone interested in buying a used OBi508 for cheap? I'll throw in free UPS ground shipping to the lower 48.

tellermetrix:
I'm selling my OBi508 on ebay if anyone is interested. No reserve

http://www.ebay.com/itm/171988822754

Navigation

[0] Message Index