Obion Number as an extension

(1/2) > >>

Vgraham:
I want to set up my Obion Number as an extension in obiplus using an obi202. I currently have 5 Cisco phones in the system and would like to be able have someone in the office dial an extension and ring my Obion Iphone and also make it part of a group. Any help would be greatly appreciated.  ???

azrobert:
On page 30 of the OBiPlus doc there are User extension examples.
http://www.obihai.com/docs/OBiPLUSTutorial.pdf

I never used OBiPlus, but it looks like you can setup OBion like extension 108 in the example.
Just use your OBion OBi number.

Vgraham:
Thanks for your response. Yes it appears that way in the diagram in the manual but in obiplus you can only enter the IP address of the users phone when adding a user. It will not accept the obion number. Must be an earlier version of obiplus.

azrobert:
You should be able to setup the OBion as an outbound number. If you do it this way, OBion will not be in a group.

OBion should already be setup on speed dial#1. Just dial the speed dial number to call OBion.

or

On page 41 of the user guide is an example of outbound calls.
Setup an outbound call like this:
Trunk: PP
Dial Prefix: 9
Leading Pattern: 290111111

Dial 9290111111

Change 290111111 to the OBi number of OBion

I know how to route call inbound calls to OBion on a native OBi202, but I don't know how OBiPlus interfaces with the OBi202. If you want this function please post the following and maybe I can figure it out.

Voice Services -> SPx Service: X_InboundCallRoute

Vgraham:
Thanks for the help. Here is the contents of Voice Services -> SPx Service: X_InboundCallRoute
{(OBi numbers|OBi number):aa},{ph1}

Navigation

[0] Message Index

[#] Next page