iphone does not ring.

(1/4) > >>

Dranon2:
Cisco ip phone sing obi 200 does not ring. I can call out fine the phone just does not ring incoming.  Use GV 2 lines. My obi1032 phone rings fine as does my obi202.

azrobert:
On the trunk you want to route to the IP phone
Voice Services -> SPx Service -> InboundCallRoute:
Assuming the current setting is:
ph
Change it to:
ph,spn(anything@xx.xx.xx.xx:5060,ui=$1)

Change spn to a any SP number defined as SIP (not GV)
xx.xx.xx.xx:5060 is the IP address and port of the IP phone.
ui;=$1 will pass the callerid

Dranon2:
This did not work ip phone still does not ring.  When you "anything@192.168.0.5" do you literally mean "anything" or any word or is the ip phone assigned something in that spot?

It also does not ring when you speed dial the obi directly.

azrobert:
The string before pound sign on a URI call to a provider is the outbound number, but should be ignored by the IP phone. You can use any character string, but I normally use "0" without the quotes. I believe some people have had problems with URI calls to CISCO phones, so maybe there is something quirky about them.

Make sure you are using the correct port number. When you omit port number it will default to 5060. I assume you are registering the IP phone to a SP trunk on the OBi. You can check the OBi System Status to see the IP address and port of the IP phone. It is listed under SPx Service Status. If you are registering more than 1 IP phone to the SP trunk, only the IP address and port of the last phone to register will be displayed.

Dranon2:
Quote from: azrobert on March 02, 2015, 01:02:39 pm

The string before pound sign on a URI call to a provider is the outbound number, but should be ignored by the IP phone. You can use any character string, but I normally use "0" without the quotes. I believe some people have had problems with URI calls to CISCO phones, so maybe there is something quirky about them.
I HAVE NO IDEA WHAT YOU MEAN BY THIS? Pound sign URI call?
Make sure you are using the correct port number. When you omit port number it will default to 5060. I assume you are registering the IP phone to a SP trunk on the OBi. You can check the OBi System Status to see the IP address and port of the IP phone. It is listed under SPx Service Status. If you are registering more than 1 IP phone to the SP trunk, only the IP address and port of the last phone to register will be displayed.
Only 1 ip phone and it registers fine.

Navigation

[0] Message Index

[#] Next page