Obi110 and MyNetFone (AU)

(1/5) > >>

dvlpr:
Hello all,

Just connected up my new Obi110, configured it with the settings from the Aussie thread and I'd now like to enter my VoIP provider details in. I'm using MyNetFone and was wondering whether I need to tweak any of the advanced settings or is entering the sip addresses and logins enough (I did a quick search here, but didn't find a thread with such information - if there's one, please point me to it).

Thanks!

RonR:
ProxyServer, AuthUserName, AuthPassword, and (optionally) CallerIDName are usually enough to get you going.

dvlpr:
Quote from: RonR on May 31, 2011, 06:58:47 am

ProxyServer, AuthUserName, AuthPassword, and (optionally) CallerIDName are usually enough to get you going.


Yep, I've setup those and things seem to be working - I was just wondering whether I should tweak anything else  ;D

On a side note, is this rule ok (set in Phone port's OutboundCallRoute):

{0011xx.:sp1},{@:li}

Basically, all I want is for any number beginning with 0011 to go through my SP1 and the rest through PSTN.

Thanks!

RonR:
I would prefer leaving the PHONE Port DigitMap and OutboundCallRoute at Default and making these changes:


Physical Interfaces -> PHONE Port -> PrimaryLine : PSTN Line


Physical Interfaces -> LINE Port -> DigitMap:

(<**1>0011xx.|xxxxxxxS4|1xxxxxxxxxx|xx.)


Service Providers -> ITSP Profile A -> General -> DigitMap:

(0011xx.|1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)

dvlpr:
Ok, thank you - I'll give those a try once I go through the docs and understand the rules.

Navigation

[0] Message Index

[#] Next page