Obi110 and MyNetFone (AU)
QBZappy:
dvlpr,
Quote from: dvlpr on June 06, 2011, 05:44:27 am
What happens when registration fails?
If registration fails you should see something like this in the system status>SP1/2 Service Status
Register Failed: 401 <---- code will vary depending on the reason why it did not register
dvlpr:
Quote from: QBZappy on June 06, 2011, 08:05:25 am
dvlpr,
If registration fails you should see something like this in the system status>SP1/2 Service Status
Register Failed: 401 <---- code will vary depending on the reason why it did not register
Ok, haven't seen that (yet). I assume it doesn't recover on its own without my intervention, so that means it's not failing for me.
The only settings I've changed are these: http://www.obitalk.com/forum/index.php?topic=616.0 - the rest are defaults.
jtmarcot:
Thanks qbzappy and dvlpr. Once my unit fails to register, it remains that way until I set a new MyNetFone sip address (I tend to shuffle between sip and sip20). I've tried forwarding ports thru on my modem, and putting the obi on the dmz, but no luck. The latest attempt has been to disable sip_alg on my modem. I haven't had a registration failure since doing that last night, but I woke up this morning to a disconnected obi (the power light was on, but no others). I've rebooted the device, and we'll see how it goes from here.
QBZappy:
dvlpr,
Registration period comes from this setting:
Service Providers>ITSP Profile A/B>SIP>RegistrationPeriod = 60 <----------- Default setting
When you look at the system staus page "Status" it dose not indicate that the OBi is loosing registration. It just happens to be a snapshot of the moment indicating how many seconds before it tries to reg again. This value can be modified if needed to suit your particular SP.
dvlpr:
Quote from: jtmarcot on June 07, 2011, 04:07:56 pm
Thanks qbzappy and dvlpr. Once my unit fails to register, it remains that way until I set a new MyNetFone sip address (I tend to shuffle between sip and sip20). I've tried forwarding ports thru on my modem, and putting the obi on the dmz, but no luck. The latest attempt has been to disable sip_alg on my modem. I haven't had a registration failure since doing that last night, but I woke up this morning to a disconnected obi (the power light was on, but no others). I've rebooted the device, and we'll see how it goes from here.
Not sure if it matters, but I use sip00.mynetfone.com.au
Navigation
[0] Message Index
[#] Next page
[*] Previous page