[Resolved]User Digitmap

<< < (2/3) > >>

yellowpage:
I check the firmware is 4581.
I put your suggested inbound route along with my cell#. Submit the change and reboot the box. Call Obi with cell. It still rings.  ???
Quote from: azrobert on March 25, 2015, 08:49:26 am

The code looks good to me, so I'm guessing with the following.
Make sure you are at the current firmware level (4581).
I had a problem with a User DigitMap working in the past.
That is why I'm suggesting checking the FW.
I fixed the problem by putting all the code in the inbound route like this:
{(8888001250|8773639588|8009311026):},{ph}

If you have another phone number temporarily include it in the list, so you don't have to wait for the telemarketer to call.

After you submit the changes does the OBi re-boot?

azrobert:
Are you using the local interface or OBiTalk to make your configuration changes?
If you are using the local interface, please check your changes to see if they are still intact.

yellowpage:
I use the OBiTalk portal through expert mode.

azrobert:
You said:
Quote

In physical interface->line->Inbound Call Route, I enter:
{(MTelemarketers):},{ph}

You also said:
Quote

Checked history. It shows:From 'xx' SP1(8009311026) To PH1


If calls are coming in via SP1, you are putting the code in the wrong place.
It should go here:
Voice Services -> SP1 Service -> X_InboundCallRoute

drgeoff:
The example you gave from Call History shows the call coming in on SP1 but the blocking you have set up is for calls coming in on the LINE port of your 110.

Edit: azrobert has beaten me to saying the same.

Navigation

[0] Message Index

[#] Next page

[*] Previous page