OBI-FREEPBX and CID
rjstott:
I am using the OBI to convert a POTS line into a SIP channel for my FreePBX system. It works ok but I can not get the incoming CID to be sent to FreePBX. What I get at FreePBX is "AuthUserName" and on my SIP extension I get for example OBI11 and 11, where the 11 comes from OBI11 ('cos when I had OBI110 it sent 110).
What I want and need is the incoming CID?
As an aside incoming and outgoing call setup times are very slow. What should I change to speed this up?
azrobert:
How are you routing the call to Freepbx?
You need to route it with an SIP URI like this:
spx(100@xx.xx.xx.xx:pppp)
Where xx.xx.xx.xx:pppp is the IP address and port of Asterisk.
spx must point to a SP trunk defined as SIP (not GV).
Then change the following parm for the ITSP Profile for spx
Service Providers -> ITSP Profile X SIP -> X_SpoofCallerID: Checked
rjstott:
I think those settings are ok (URI = OBI11@192.168.1.89) and X_SpoofCallerID: is Checked. The calls come through as I first said just with OBI11 as the name and 11 as the number, which is what is shown on a phone.
azrobert:
Try URI = OBI11@192.168.1.89;ui=$1 and X_SpoofCallerID: Un-Checked.
rjstott:
Hi,
Thanks for trying. Its not fixed but no worse. There is something odd going on when I look in the OBI call history as there is no CID logged in there either. BUT I have seen incoming CID in there AND I'm sure one record which had one changed and it was cleared???
Just for more info I'm in France and connected to a Livebox for the trunk. This does give CID data to a normal phone.
Navigation
[0] Message Index
[#] Next page