Possibility to Create Autodial feature?

<< < (2/2)

ShyGaz:
Quote from: drgeoff on April 06, 2015, 10:59:10 am

Try moving the '>' to give <9:xxxxxxxxx>


Ok! I'll try that later tonight when I go back and I'll post an update.

Thanks!

202Owner:
Quote from: drgeoff on April 06, 2015, 09:35:38 am

Quote from: 202Owner on April 06, 2015, 05:11:03 am

Page 199 in the OBi Admin Guide http://www.obihai.com/docs/OBiDeviceAdminGuide.pdf suggests that <S0:1234> is the syntax for a hotline that dials 1234.  I have not tried this.

A hotline dials the number immediately the phone goes off-hook. Changing that 0 to another number gives a warmline.  Eg <S5:1234> will dial 1234 five seconds after the phone is taken off-hook unless a digit is dialled during that 5 seconds.  My Obi110 has been configured with such a warmline for more than 2 years.


Yes, I know.  It's in the manual.  ;)

drgeoff:
Quote from: 202Owner on April 06, 2015, 11:06:30 am

Yes, I know.  It's in the manual.  ;)

Just like the answers to perhaps 90% of the questions asked on these forums.  :)

munozj:
I'm sure this is something obvious but I can't seam to figure it out.. to make this work I'm assuming I need to replace the information in the Digit Map field of SP1 with <S0:5551212> for the device to automation dial 5551212 when the phone goes off-hook.  I've tried this but I only get dial tone when I pickup the phone.  I also tried replacing the Digit Map info of the Physical Interface Phone1 port with the same results. 

I'm assuming I'm just entering the syntax in the wrong field but I'm not sure which field I should be using. 

drgeoff:
Insert that immediately after the opening ( in the PHONE Port Digit Map. Then put a | as separator between that <...:....> you just inserted and whatever was there already.

Also you may need to read and understand the sticky post http://www.obitalk.com/forum/index.php?topic=61.msg109#msg109 .  You are probably making changes using the onboard UI and they are being overwritten by the portal.  If so, use Expert Mode on the portal to make changes.

Navigation

[0] Message Index

[*] Previous page