obi200 with justvoip
azrobert:
As usual I didn't read the entire thread. I don't think there is a wizard for JustVoip.
To manually configure JustVoip:
Service Providers -> ITSP Profile D -> SIP -> ProxyServer : sip.justvoip.com
Voice Services -> SP4 Service -> AuthUserName : Your JustVoip userid
Voice Services -> SP4 Service -> AuthPassword : Your JustVoip PW
Voice Services -> SP4 Service -> X_ServProvProfile : D
Edit:
Click Status then click System Status.
Scroll down to SP4 Status to see if JustVoip is registered.
GAKW:
Thanks, I also changed
Service Providers -> ITSP Profile D -> SIP -> RegistrarServer : sip.justvoip.com
Since this appear on this instructions. I am not sure if it makes a difference but everything is working :)
One question though, I ended up using manual configuration but of curiosity followed the instructions you indicated to sync obi and obitalk. However it doesnt seem to work for me
5. Create a Configuration Backup locally in System Management/Device Update.
Check Use OBi Version.
6. In OBiTalk Expert import the backup. Now the OBi and OBiTalk will be in sync.
7. Locally enable OBiTalk Provisioning.
After #6 I click obitalk expert to actually see the configuration but no new justvoip values are included.
Any suggestions?
When doing #5 backup i only selected Use OBi Version but not the other two (Incl. Running Status Incl. Default Value)
azrobert:
Is there a "!" next to the value?
This indicates the value is different than the default.
Uncheck the box under OBiTalk Setting to see the real value.
This is one of the several reasons why I don't use OBiTalk.
I believe when the Proxy and Registrar Server are the same you don't need to define the Registrar Server.
GAKW:
Thanks, I can see now the values.
Is the OBI Dashboard also supposed to get updated through restore? It doesnt show SP4 (even though OBI expert has all the settings)
azrobert:
Quote from: GAKW on April 11, 2015, 12:12:11 pm
Is the OBI Dashboard also supposed to get updated through restore? It doesnt show SP4 (even though OBI expert has all the settings)
I don't use OBiTalk, so I don't know the answer to your question.
The only time I used OBiTalk was to define GV and then I switched back to the local interface.
All my manually defined trunks don't show on the dashboard after an import.
Maybe it will show if you manually define it with OBi Expert.
Navigation
[0] Message Index
[*] Previous page