can't make outgoing calls Obi110 & FPL

(1/3) > >>

xaveryptak:
I had FPL and GV set up on Obi110 with a landline working well. Then I ported my landline number to FPL and now I cannot make outbound calls. Incoming calls work fine. I get the message " the number you've dialed was rejected by service provider, reason #400. I've resetted my Obi and tried different digiMaps but to no avail. Any advice?

drgeoff:
Point a browser at your OBi's IP address and login to its local web server.  (admin and admin if you have not changed the password.)  On the left hand side, click on Status and then Call History.  The right hand column will show what numbers the OBi actually sent and to where.  Check that they are what would be expected.

OzarkEdge:
Could it be that you route outbound to your landline, LI1, which is now no longer in service, post port?

Edit:  Probably not given the SIP response code 400.  Here is a list of SIP codes:  http://www.3cx.com/pbx/sip-responses/.  As suggested above, check your OBi Call History to see what number your dial plan is routing to where.

OE

xaveryptak:
thanks for your help. My call history shows for all outbound calls:"End Call (400 Bad Request(Bad Content-Length (larger than datagram)))". Unfortunately, I still don't know how to fix it.

drgeoff:
A lot more information would help.

What Service Providers are currently on the 110?  If more than FPL is it all outgoing calls that are failing or only those via FPL?  How are you configuring the SPs?  Is the Call History not showing anything like '1234567890@freephoneline.ca'?

Navigation

[0] Message Index

[#] Next page