OBiWiFi_Setup not showing up

<< < (3/3)

WelshPaul:
Happy my solution worked for you.

The *27 method I believe should work on the OBi1000 series devices as my OBi1032 has the parameter *27, run OBiWiFi as Access Point, wifiap() listed under star codes as does my OBi202.

There must be a bug in the firmware so just in case OBIHAI don't pick it up here I will submit a post in the OBi1032 Beta Testers Forum and hopefully this will be sorted in the next firmware release.

u4ious:
1)  Plug the OBI Wifi Adaptor into the one USB port on the back of the OBI-1022 Phone
2)  Power it up
3)  Wait for the screen to become steady.
4)  Press the Key with the House Icon (Home)
5)  Press the Down arrow 5 times to reach 'Settings'
6)  Press the button with the check mark on it to enter settings.
7)  Press the Down arrow once to reach 'WiFi' setting
8 )  Press the button with the check mark to select WiFi
9)  If the checkbox 'Enable' isn't checked, press the button with the check mark to toggle it on.
10)  Press the Down arrow twice to reach the SSID box and press the 'Scan' button (the left most of the 4 task buttons below the screen.
11) Use the arrows to select your SSID/Wifi Router or Access point.
12) Press the check mark button to select your SSID and then arrow down twice to enter the password for your Network.
Note:  you'll find the extra non-alpha/numeric characters needed on the keypad 1, *, 0 and # keys.

That's about it!

Navigation

[0] Message Index

[*] Previous page