Suddenly White Noise
RNet:
I've had my obi 200 as a backup line for about 2 months, everything seemed to work fine with the device.
Today my dad called and I was closer to the obi, so I picked up that line and all I hear is static. The phone I am using is not a very high end, just a vTech cordless, but I wanted to check here for ideas / experiences.
I googled some, finding to try and change it to 100mb full duplex, but I couldn't find the setting in the obi control panel, nor did the 'dial to config' the post spoke of work for me.
Any ideas or experiences?
restamp:
I've noticed this same glitchiness (answer or make a call, get white noise after the connection is established) on my OBi200 as well. Usually (maybe always), when it occurs, it occurs on the first call after a boot of some sort, but it is rare: It doesn't happen after every boot. Had your 200 perhaps been rebooted recently? (It's only happened a couple times to me, so I can't say whether it is something which only affects GV, or if it also affects my SIP lines as well.)
OzarkEdge:
Change your phone cord and try a different/wired phone.
OE
azrobert:
This is how to set 100mb full duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
Boykin:
There might be a bad codec on the 200. After the latest firmware update on my 3 1032s, all incoming calls on all 3 1032s had white noise when you picked up the call. Outgoing calls worked fine. I had to disable codec G726R32 to get them to work properly.
Navigation
[0] Message Index
[#] Next page