Firmware update for 20x series
SteveInWA:
Quote from: Almighty1 on March 28, 2017, 07:50:22 pm
On my Obi202, I upgraded from 5562 to 5589. It rebooted and it showed 5589 but somehow when I checked it a bit later, it seems to be 5562 again. So I repeat the process and it always upgrades to 5589 after rebooting but then later, same thing happens and it goes back to 5562. The file OBi202-3-1-1-5589.fw I have is:
Size: 11,647,648 bytes
Log into your OBiTALK web portal account. Click on your OBi 202. Get into "Expert configuration" mode. Go to System Management-->Auto Provisioning. Edit it to look like the screenshot below. Note: you must remove both check marks to the left before you can change anything. Click the Submit button after editing.
Almighty1:
Thanks Steve. I figured out what happened since before, I had put it on System Start with the Firmware URL pointing to 5562 as I couldn't get the web interface working but now it works so I was upgrading from a file.
SteveInWA:
Ha!
Glad you figured it out.
VailAZ:
So, is 3.1.1.-5589 the latest update for the Obi200? I just purchased mine, it's working fine, but I want to make sure I've got the latest firmware installed. ***6 always says no update available. It came with 3.1.1-5463.
Finding firmware revision level information on the website seems unusually daunting...
Thanks.
azrobert:
Quote from: VailAZ on May 12, 2017, 12:56:27 pm
***6 always says no update available.
Download the FW with the below link. Then install using the local interface.
Enter IP address of OBi200.
Default UserID and PW are both "admin".
Go to System Management -> Device Update -> Firmware Update
http://fw.obihai.com/OBi202-3-1-1-5589.fw
Navigation
[0] Message Index
[#] Next page
[*] Previous page