Firmware update for 20x series
NKYadav:
I'm curious about one thing:
According to the information I have found, 5921 is the latest fw for Obi2 devices, as of May 2019. However, when I dl it using FDM, with server side time & date enabled, the file actually has a dat of 18 Sep 2018. I realize this is inconsequential, but I'm still curious - does the writing on the forums means that, as of May 2019, nothing newer than the build from 18 Sep 2018 was produced for Obi2s?
At any rate, I had previously updated to 5921, but I was having issues with GV making overseas calls (yes, account is funded) - so now I'm going to try to revert to 5859 and see if it makes a difference.
I'm using this post (and the subsequent posts) as a basis on what I should try next:
https://www.obitalk.com/forum/index.php?topic=9983.msg91700#msg91700
After that, if it still does not work, I'll try to completely reset and start from scratch, as I've never, since I bought the devices in 2014, done that....
flamaest@gmail.com:
Quote from: Raf66 on July 31, 2019, 12:15:13 pm
Quote from: SillyConVal on July 30, 2019, 08:41:57 am
After updating to the "OBi202-3-2-2-5921EX-332148940.fw" firmware on my Obi202, I now have the problem that every 2 days on average, when I attempt to place an out-going call, I get the verbal error message: "The number you dialed has not received a response from the service provider." Curiously I can still receive inbound calls while this issue is in effect. The only remedy that I have found for this is to power-cycle the Obi ATA device. But then the same problem will occur a couple of days later. I have already tried power-cycling my cable modem, router, and ethernet switch, but to no avail. Is anyone else experiencing this or have any suggestions as to a remedy?
I am having the same issue, not sure how often it happens because I make a call every once in a while.
As in your case, power cycling the OBi202 is the (temporary) solution.
Same EXACT issue here, on 5921EX, issue has been happening 2-3 times per day since I applied the update on Aug 9th 2019.
vit5421:
Quote from: SillyConVal on July 30, 2019, 08:41:57 am
After updating to the "OBi202-3-2-2-5921EX-332148940.fw" firmware on my Obi202, I now have the problem that every 2 days on average, when I attempt to place an out-going call, I get the verbal error message: "The number you dialed has not received a response from the service provider." Curiously I can still receive inbound calls while this issue is in effect. The only remedy that I have found for this is to power-cycle the Obi ATA device. But then the same problem will occur a couple of days later. I have already tried power-cycling my cable modem, router, and ethernet switch, but to no avail. Is anyone else experiencing this or have any suggestions as to a remedy?
Same problem just started here with GV. Downgrade it to 3.2.2 (Build: 5859EX) and all looks good
flamaest@gmail.com:
Can you please provide a link to the 3.2.2 file?
Is this still fixed for you?
vit5421:
Quote from: flamaest@gmail.com on March 05, 2020, 01:38:30 pm
Can you please provide a link to the 3.2.2 file?
Is this still fixed for you?
Works great so far.
Attached
Navigation
[0] Message Index
[#] Next page
[*] Previous page