My answering machine is picking up too soon with the dual ring on SP2. SP1 is fine as it has only one ring/incoming ring How can I make both sp1 and sp2 ring only once for each incoming ring?
/Voice Services/SPn Service/X_Ringprofile. Set the SP2 one to be the same as is currently set for SP1. And lower down that page ditto for X_DefaultRing.
You can customise what the specific 10 patterns in each profile are at /RingSettings/Ring Profile A (or B)/. Consult the Admin Guide http://www.obihai.com/OBiDeviceAdminGuide#_Toc367543113 if you want to know the syntax and values.
Normally, when you share a phone port with a fax, SP2 is set to double ring. The fax is then setup for Distinctive Ring to answer only on a double ring. Now the fax won't pick up on an inbound SP1 call.
X_RingProfile= A and X_DefaultRing=3 is a double ring.
THANK YOU!! :D
I could not get the SP2 to stay in A like SP1, it always came back B after rebooting, but I was able to change the ring profile 1 in B to be just like A, and both lines now ring once. I just use this like a home phone, no fax or other extras wanted, my own answering machine is what I want storing messages. Now it's PERFECT! Hope it stays... ?? ;)
Quote from: Buzzy on December 23, 2016, 11:20:08 AM
I could not get the SP2 to stay in A like SP1, it always came back B after rebooting,
Sure you are not changing things via the device's local web GUI but still have OBiTALK provisioning enabled?