Quick question, lets say you want to send a dialout sequence like *67<½ second pause>5551212 to the OBi110's line port, because the PSTN provider requires the pause. Is there a specific character that can be inserted after the *67 to make the pause happen? I know on the SPA-3000/SPA-3102 devices you can use a w at the appropriate point in the dial string, but that doesn't seem to work with the OBi110, so I was wondering if there might be a different character that would work (hopefully something that FreePBX won't object to)? ???
<S1> should give you a one second pause. I'm not sure if you can get .5
Unfortunately the *67 code is interpreted by the OBi, and does not get passed onto the Line port.
Suggest to press # first to hear the Line port dial tone, and dial normally.
Is this a work around found in this thread for the *67 being processed by the Obi?
General Support > Installation and Set-Up (Devices) > Dialing *75 from your OBi, speed dial entry in VoIP.ms phone book
Quote from: OBiSupport on December 07, 2010, 04:25:39 PM
A service provider may use any digit combination for your configuration of speed dial entry.
Service Provider: VoIP.ms has reserved speed dial numbers: *7501 - *7599
To be able to use the VoIP.ms speed dials in your OBi, you need to do two things:
1. Delete or modify the Star Code entry(ies) that has *75.
In OBi's default configuration, you will see in both "Star Code Profile A" and "Star Code Profile B", that *75 is referenced as Code 22 for (Check Speed Dial).
2. Add *75xx to your SP DigitMap. By taking out *75 in the Star code profile(s), you won't be able to dial *75 until you add *75xx to your DigitMap, so it looks like (*75xx|1xx......etc....).
STOP! WE'RE ALL WRONG!! ;D
First, I apologize. The "w" works just fine. What isn't working on the provider line is *67 for some reason. Even if I attach a phone and dial it I only get a fast busy. That is relatively new behavior (and I'll bet I know when it happened) so I started using *70 for testing and left the phone hooked up and could hear it send the *70, then pause half a second, then send the rest of the number. And I'm pretty sure it was sending the *67 just fine as well, but the line wasn't taking it.
The <S1> might work but FreePBX hates it, and even when I tried a trick to force it, it was still dialing extra digits. A lone S (no 1, nor angle brackets) seemed to produce a one second (or so) pause.
Anyway, sorry to lead everyone on a wild goose chase, I didn't know that *67 had stopped working so now I need to investigate that. :-[
As far as I know, "w" is undocumented in the admin manual. Does it serve the same purpose as <S>?
In listening to the tones go out my perception was that the w might give a ½ second wait, same as on the SPA's. It definitely seemed shorter than the S to me, but keep in mind I wasn't timing it with any kind of precise timer so that's just my perception.