Hi, I am having an issue connecting to my Obi202.
I have Google Voice and voip.ms setup and I wanted to change the voip.ms account. I can access it online on ObiTalk, but it's not working after I made the changes, so I tried to connect to the device via the IP address. I am getting a URL not found error when I enter the 10.0.0.x IP address that I got when I dialed ***1 from the phone.
Before you can log in via the WAN port you need to enable WAN administration from OBi Phone:
Dial ***0 from the OBi phone
Enter 30#
Press 1 to Enter a New Value
Press 1# to Enable
Press 1 to Save
Thank you Taoman.
Sorry, I am very inexperienced with this. What is the value I would be entering when prompted?
I didn't have a problem connecting before. I'm not sure what changed. I have a network cable coming from my router to the Internet port in the Obi. The LAN port is empty.
Quote from: asdf123 on September 05, 2021, 03:44:00 PM
Thank you Taoman.
What is the value I would be entering when prompted?
Just follow the directions in my post step-by-step. The value is entered in the 4th step.
Quote from: PolyNOTE: For the OBi202 ATA Device model, to access the integral local web-page via the WAN port (if prompted), at phone plugged-in, dial: ***0, 30#, 1, 1# and 1.
My Obi202 has been working fine.............................
Check to see which firmware version you have running.
I recently updated my firmware, as suggested by an Obi
support rep.
It not only didn't fix my problem, it disabled the Web
interface on my OBi202. I had to re-enable it manually
for it to work again.