I swapped my (working perfectly) Obi101 for an Obi202. I configured it for use with GV and Phonepower via Obitalk. It worked for a few days. Since then I have been getting failures to register with 403 codes.
Phonepower support gave the following instructions - which I executed. However, will no occasionally register, but will not stay registered.
.......
Obhai has changed their Re-sync process due to problems with the configuration they
were pushing to the devices.
1) What you'll need to do now is Enable your Sip credentials in the Phone power account portal
Under MODIFY SERVICES -->SIP CREDENTIALS. Just enable them to display the information that
needs to be entered on the obihai portal (Make sure to NOT disable them)
Ive attached screenshots in a zip file to guide you where to go and what to enter.
2) FIRST In Obihai where there was the icon for Phonepower, You now click on the link at the
bottom of that page for "OTHER PROVIDERS" and you'll see a link for phonepower. (STEPS 1-3 SCREENSHOTS)
3) Click on that link and then manually enter the Sip credential info from the
phonepower account portal into the fields in the obihai page. (STEP 4 SCREENSHOT)
Then press submit
4), STEP #5 Go back to the dashboard and click on the 9-digit Obihai device number at the top
a) Click on EXPERT CONFIGURATION and then click on ENTER EXPERT CONFIGURATION
b) Goto SYSTEM ADMINISTRATION--->AUTO PROVISIONING
c) Locate ITSP PROVISIONING
d) You need to edit the first two parameters.. to make them editable, uncheck the box to the left of the
parameter and you will see the check move to the box to the left of it.. Uncheck that box as well and you'll
be able to make changes.
e) Edit as follows: (See STEP 5 SCREENSHOT )
f) METHOD: Change to "PERIODICALLY"
g) INTERVAL: Set to 30 (this will allow you to make changes and Update to the device without restarting it)
h) Press submit at the bottom and your device will update..
The last two screenshots are for setting the ports and Protocols(STEPS 7 &
. Once youve set those ..
reboot the obihai to refresh the changes in the device and it should show "REGISTERED" in the Dashboard status window.
FOR STEP 8
COPY THE ENTIRE STRING BELOW FROM THE FIRST TO THE LAST PAREN
(**|[3469]11|0|00|1xxxxxxxxxx|<1>[2-9]xxxxxxxxxS0|*21|*50xxxx|*51xxxx|*52xxxx|*53xxxx|*54|*6[013569]|*6[27]xx.|*77|*[789]2xx.|*73|*74[0-1][0-9]*xxxxxxxxxx|*75[0-1][0-9]|*8[137]|90xxxx|*93|*96|011xx.|xx.|(Mipd)|[^*#]@@.)
Paste string into the DigitMap field as shown on STEP 8 Screenshot... Press Submit and restart the Obihai device.
.......