Quote from: makitso on March 24, 2012, 06:01:57 AM
I have my Ooma connected to the Obi110 as suggested and it works find. The only problem is that after dialing a phone number, it takes about 10 seconds for a ring to start. If I use the Obi options, e.g. **1 and then the phone number, the ring starts immediately. Any way to adjust this?
The problem is likely the LINE Port DigitMap. Select the most applicable one from these choices:
LINE Port DigitMap for areas with 7- and 11-digit dialing:
(10-digit numbers will be extended to 11-digits by adding a leading 1)
Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|[2-9]xxxxxx|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.)
LINE Port DigitMap for areas with 7-, 10-, and 11-digit dialing:
Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|[2-9]xxxxxx|[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.)
LINE Port DigitMap for areas with 10- and 11-digit dialing:
Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.)
LINE Port DigitMap for areas with 11-digit dialing:
(10-digit numbers will be extended to 11-digits by adding a leading 1)
Physical Interfaces -> LINE Port -> DigitMap:
([2-9]11S0|<1>[2-9]xxxxxxxxx|1xxxxxxxxxx|011xx.)
In all cases, dialing # after the last digit will tell the OBi the end of the number has been reached and calling may begin.