News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

!Call Bar ??

Started by dstange, July 21, 2015, 05:34:13 AM

Previous topic - Next topic

dstange

I want to use the !Call Bar function to deny calling of 3 specific phone numbers. Could someone help me with this? I have an Obi100 with GV on SP1 in the US.I'm just confused of what the correct formatting is and where to enter the rules. So any examples and direction would be greatly appreciated.

TIA

azrobert

#1
I think this is what you're asking
Physical Interfaces -> Phone1 Port -> DigitMap
Add the following AFTER the beginning parenthesis:
!1?8005551212|!1?8005551313|!1?8005551414|

Use OBi Expert to make this change
The 1? will check for 10 or 11 digits

dstange

So my digit map would look like this?

(!1?8005551212|!1?8005551313|!1?8005551414|[1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911|**0|***|#|**1(Msp1)|**2(Msp2)|**9(Mpp)|(Mpli))

obviously I'd need to change the numbers to my needs of course.

azrobert

Quote from: dstange on July 21, 2015, 08:39:03 AM
So my digit map would look like this?

(!1?8005551212|!1?8005551313|!1?8005551414|[1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911|**0|***|#|**1(Msp1)|**2(Msp2)|**9(Mpp)|(Mpli))

obviously I'd need to change the numbers to my needs of course.

Correct

dstange

Thank you very much! I remoted in from work so I'll test it when I get home! Thanks again.

dstange

For some reason after I create the map, after I reboot it just goes back to the default digitmap, any ideas?

azrobert

You can only use one method, local interface or OBiTalk to configure your OBi.
If you use the local interface to configure your OBi you must disable OBiTalk auto provisioning, otherwise OBiTalk will overlay any changes you make.

System Management -> Auto Provisioning
Under OBiTalk Provisioning
Method: Disabled

If you are using OBiTalk to configure your OBi, is there a red ! next to the value?
If there is then uncheck both boxes next to the value to see the real value.
The red ! means the value is not the default.

dstange

Just logged into the Obi locally, disabled auto provisioning and made changes and they look like they held. Will try again when I get home and post results. I remoted into my laptop @ home then logged into the obi locally from there to make the changes. Thanks again everyone for all your help.

dstange

Busy signal on the lines I designated for call bar! Thanks again.