December 15, 2017, 12:11:09 am *
Welcome, Guest. Please login or register.
   Forum Home   Search Login Register OBiTALK  
Pages: [1]
Author Topic: How to access OBi202's webpage  (Read 63 times)
Posts: 7

« on: December 12, 2017, 08:26:05 pm »

during setup, there is an "i" button that shows that I can access the device's webpage by typing in the URL  I tried just the numbers an I tried to no avail.  It timed out.  And I have tried multiple times.

I read in another post on manually updating the firmware, it states:
Access the web page of the OBi device (OBi via Internet/WAN Port):

    From a phone attached to the PHONE port of the OBi dial * * * 1
    The IP address of the OBi will be read to you
    Open a new browser window on your PC and enter the IP address of the OBi.

The IP address over the phone is different from the "i" button above.  When I tried this #, I get "Requested URL was not found"

My OBi202 is through a router.  What is the proper URL to get access to the OBi202's web page?  Or how to find out the correct URL?

Hero Member & Beta Tester
Posts: 2723

« Reply #1 on: December 13, 2017, 03:40:21 am »

Unlike other models the OBi202 contains a router which by default is enabled between the WAN and LAN ports. Also by default, access to the onboard web server from the WAN port is disabled. It can be enabled by dialling ***0 then 30# then follow the audio prompts to enter and save a 1. You may also wish to change from router to bridge mode. See the next item in the table in the link.

Be aware that you should NOT use both the onboard web server and the portal to configure your device.
« Last Edit: December 13, 2017, 03:47:19 am by drgeoff » Logged
Pages: [1]
Jump to:  

Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC