Quote from: azrobert on January 17, 2021, 02:19:25 PM
I assume you also changed the SPA504G proxy port to 5061.
I wanted you to make an outbound call from the SPA504G with SP2 X_InboundCallRoute set to: ph
Is this what you did?
Setting it to "ph" will ring the OBi202 attached phone instead of routing to a provider. This will see if the outbound call is getting to the OBi202.
Are you running the OBi202 in Router or Bridge mode?
If you are running in Router mode, how is the SPA504G connected? To the OBi202 or your main router?
Rgr that. I understand better now. First, I have the SPA504 plugged directly to my switch. The Obi 202 is also plugged separately to the switch. Each has its own IP number.
I went to the phone admin and changed the proxy to the IP#:5061
I then changed the X_InboundCallRoute to ph and was able to get the analog phone to ring.
I then changed it back to SP1 and the analog phone still rang. Not sure why it was, however, I put the original string of {Obitalk>(xxxxxxxxx):pp},{Obitalk>(xx.):sp}. back in there and it started to work.
Is this the best script to put here? or is their something else.
I think it is in router mode, but I don't recall where to look to determine that.
I can make a outgoing call now, so problem resolved.
Thanks Again!