On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

OBI110 Line port's InboundCallRoute resets to default randomly

Started by Pakcjo, May 19, 2024, 07:46:34 PM

Previous topic - Next topic


Hello, I know this device (OBI110) is discontinued already, but I recently got one (second hand), managed to configure it with asterisk following the pinned message about it and all if fine except that sometimes the InboundCallRoute option on the line port switches back to default (ph) instead of sp1, I have no idea what could be triggering it, I have checked the uptime and it doesn't seem to be caused by a reboot.

The device's firmware version information is:    1.3.0 (Build: 2872) and hardware: 2.8.

I don't now how I can debug it further, sometimes I just go into the Line port option and noticed that the default check mark is on and the value is ph, I changed it back and after a while, goes back to default.

Any help will be greatly appreciated. Thanks


Configuration changes might not be saved permanently due to memory issues. Try rebooting your OBI110 and see if the InboundCallRoute sticks to sp1 after the reboot.