Thankyou for you reply - I received the device today and, for anyone reading this, I ordered it from Amazon and it took 6 days to get to Australia from placing the order. Highly recommended! I also had to make the country specific changes ianobi mentions, but they were straightforward using the link below (well, it doesnt work completely yet but that may be unrelated).
I have wrestled a little with setting the device up, and Im not sure where best to request help. So below is a duplicate of a support request Ive just lodged - I dont know if you are one and the same people, if not then maybe I'll await a support reply to avoid duplication .....
===================================================================
Hi.
Just received my Obi110 today. I live in Australia so configured it following
http://www.obitalk.com/forum/index.php?topic=616.0. I have disabled SP2 as I currently use only one provider. I have used simpler dial plans than the above article but do not list them here as I do not believe they are relevant, and I also believe they work as I am able to make outbound calls.
So, yes, I can make outbound calls. And I can receive inbound calls via PSTN. But I cannot receive any inbound calls made to my Voip provider (MyNetPhone).
I also have a MyNetPhone ATA (Mitron MNFMv1). This works in all aspects (inbound, outbound etc). It is connected to a LAN port on my firewall/router (Netgear WNDR3300) which has the spi firewall turned on but NO port forwarding is necessary. The OBi plugs into the same port so I deduce the lack of incoming calls cannot be a firewall issue.
The only parameter I can see that might prevent incoming calls is the SPService parameter X_InboundCallRoute which is set to default (ph).
What else should I check or could I change to try to get incoming calls?
Of lesser importance, but next on the list, outgoing caller id works with the Mitron box. It does not work with the Obi110 and comes up as "private" on the recipients phone. The caller id spoofing is the only thing I can see that might affect this, and that is set to default.
many thanks for any help.
Colin