December 12, 2018, 12:32:47 am *
Welcome, Guest. Please login or register.
   Forum Home   Search Login Register OBiTALK  
Pages: [1]
Author Topic: Home to Office Extention - Dial Tone Only  (Read 4340 times)
Posts: 1

« on: April 06, 2011, 08:18:37 am »

I went through the "Home to Office Phone System Extension Wizard:" and setup my 2 devices while both were connected to the same LAN. I used an outside FAX line to test and everything worked as expected. I could dial out using the Obi110 and receive calls in at the remote Obi110.
I then moved the `office' Obi110 to an analog line off my Toshiba phone system.
If I dial that analog extension from another phone it rings to the remote extension and work fine!
When I pickup the handset at the remote extension there is a brief ring and then I am connected to the office Obi but when I try to dial out the tones are not recognized and I continue to get just a dial tone.

I did run the firmware update and Hardware version shows 2.8 and software shows 1.2.0 (Build: 2102)

Can anyone offer any suggestions on how to fix this?
Pages: [1]
Jump to:  

Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC