News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

Call forward.

Started by k6kbm, April 18, 2011, 10:54:53 AM

Previous topic - Next topic

k6kbm

how to call forward PSTN Line to another number (not to SPI, SP2, PH, AA and LL) either busy or no answer.

RonR

If it's only incoming PSTN calls you want to forward:


Physical Interfaces -> Line Port -> CallForwardOnBusyEnable
Physical Interfaces -> Line Port -> CallForwardOnBusyNumber

Physical Interfaces -> Line Port -> CallForwardOnNoAnswerEnable
Physical Interfaces -> Line Port -> CallForwardOnNoAnswerNumber
Physical Interfaces -> Line Port -> CallForwardOnNoAnswerRingCount

guyinsb

I have a fixed GSM terminal line connected to the LINE port of my OBi110.
This lets me accept incoming calls to my previous landline # (now ported to
a T-mobile prepaid service); it also provides a 9-1-1 service.

I have CallForwardOnBusyEnable and CallForwardOnNoAnswerEnable
both enabled with the same forwarding # (3 rings for no answer).
The forwarding number goes to a Google Voice service; the CallerID
is used to ensure the call goes directly to voicemail.  This is working fine,
except after the caller hangs up, the connection is not dropped, and
the voicemail records a "offhook warning beep".

My guess is that the fixed GSM terminal thinks it has signalled "end-of-call" to
the OBi110, but the OBi110 did not detect the end-of-call.

I suspect I need to modify some parameters in the "PSTN Disconnect Detection"
section; any recommendations on where to start?

guyinsb

It looks like a good candidate for modification is DetectDisconnectTone.
However, I could use some suggestions.  Thanks.

RonR

OBi Device Administration Guide, pages 89 and 90: PSTN Disconnect Detection