News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

Anveo - Time To Get Dialtone

Started by MikePA, April 19, 2014, 10:56:39 AM

Previous topic - Next topic

MikePA

Getting a dial tone using my 110 and GV combo was almost instanteous.

I switched to Anveo, and getting a dial tone can take up to 10 seconds.

Is this normal?

Thanks

JH2011

I get instant dialtone with Obi 110 / Callcentric

SkOrPn

Quote from: MikePA on April 19, 2014, 10:56:39 AM
Getting a dial tone using my 110 and GV combo was almost instanteous.

I switched to Anveo, and getting a dial tone can take up to 10 seconds.

Is this normal?

Thanks

I also get instant perceived dial tone with my GV and 110. That is not normal to have to wait that long for a dial tone. I would maybe expect that with a free service on the other side of the world... maybe. However, I have no experience with any of these voip services other than GV. I would look for tech support from Anveo and hope they help you figure it out. What if you need E911 right NOW and have to wait 10 additional seconds just to dial it? Defeats the purpose of having a short 3-digit number to dial doesn't it?

AlanB

I have Anveo and get an instant dial tone. I've never had problems with getting a dial tone.

c3c3

Quote from: MikePA on April 19, 2014, 10:56:39 AM
getting a dial tone can take up to 10 seconds.

Dialtone is generated locally by Obi.  I get dialtone even if I unplug the Ethernet cable.

MikePA

I bounced my cable modem then the OBI box. Everything is back to normal.

I fell into the 'trap' of blaming the last thing that was changed, changing GV to Anveo, being the culprit. Odd that it worked fine for a few hours, though.

Thanks for the reminder that the dial tone comes from the OBI box.