Obi 202

[erik]

I currently have line one up and running using PhonePower, no problems. Then I tried to create a second line using Phone power again. I have think I have everything configured to keep both lines separate.
I can call out from both lines and everything works as expected. But, when I call into line two it only works on one old phone, if i plug a different phone into it then when I call I get a message that the number can't take my call now. Is there some setting that I need to change for line 2. Remember everything is working on line 1 using the same phones.

[drgeoff]

As far as I recall the default setting for a 202 is that incoming calls via all SPs are directed only to the PHONE1 socket.

Have you changed Voice Services/SP2 Service/X_InboundCallRoute to ph2.

[erik]

Ok, Starting on the OBI Dash Board, Device Configuration, SP2 Settings.
I have unchecked all the SP2 boxes and checked all the SP2 boxes.
SO while in SP2 the line that says "Incoming calls will ring on" I have checked SP2 only
Then in the settings for SP1 I have them all set to SP1.

So you are right I had to change that to get it to ring separately on each line.