Hi,
After receiving an email from Obihai about GV support, I tried to add my GV to the OBI 110 device. It said, this device needs firmware update, so I clicked yes and selected it as my primary phone line. It removed my existing SIP provider and tried adding GV but never completed. I thought may be, I need to remove my device and add again. So I deleted the device from mu ObiTalk dashboard. I tried to add this device again but it doesn't respond to initial setup (no response to the dial **5-####). Only sign I see is red light blinking. I checked the Obi Manual, red light blinking means "device is upgrading, do not unplug". It has been two days, my OBI 110 is dead like a brick.
I need get this phone working again as it is my primary source of communication with my home based parents. I am repenting big time, why did I even consider adding GV to my already running system and causing lot of inconvenience to parents.
I haven't tried the hard-reset using paper clip as mentioned in one of the earlier threads.
If the experts on this community can help me to restore my OBi-110, I would be very grateful!
Sincerely,
JK.