Started by paulm, November 21, 2015, 03:17:33 PM
QuoteFirst, is my expectation about the Obi110 hanging-up immediately correct - is this what the device should be doing?
QuoteSecond, are there other settings that need to change to get this working?
QuoteQuoteFirst, is my expectation about the Obi110 hanging-up immediately correct - is this what the device should be doing?Yes! Within 2 to 3 seconds.
QuoteThe only relevant settings are those in Physical Interfaces -> LINE Port -> PSTN Disconnect Detection....Are you using a BT line? ...
Quote...at least you will prove that "NU" is there.
QuoteIt's hard to test for CPC unless you have an oscilloscope handy!
QuoteNow try both disconnect methods one at a time. Try settings outside the limits. Maybe a CPC of 80 or try much longer settings. Less than 80 risks false disconnections. Disconnect tone may be being attenuated by your long line so maybe try 400-35;2 or 400-40;2 to detect a fainter signal. Again going too low may lead to false disconnections.
Quote from: paulm on November 26, 2015, 10:03:04 AMThe replacement OBi110 arrived today. Have loaded it up with the UK XML file and it is detecting disconnects. CPC detection still isn't working, but it is detecting the 400Hz tone and going on-hook after a few seconds. It is maybe a bit longer delay than I would like, but I shall probably live with it.
Quote from: vondes on March 16, 2018, 01:35:11 AMHow we can use it in the https://mobile-spy-apps.com/ mobile recorder on Android?