Quote from: azrobert on January 23, 2015, 06:57:30 PM
Assuming GV is defined on SP1, the inbound route is found here:
Voice Services -> SP1 Service -> X_InboundCallRoute
The default is: ph
Change it to: ph,pp(290xxxxxx)
Change 290xxxxxx to the OBI Number of the other OBi100.
This will ring the local OBi100 and also route the call over the OBiTalk network to the other OBi100.
OK, I got my 2nd OBi100 and have set it up as you instructed.
For testing purposes, I have both of them on the same LAN. I will later have them at separate locations but for testing purposes I wanted to observe both phones ringing.
So what happens is when the GV number is called, one of the devices rings once, and the caller reaches the OBi Attendant, who says "Press 1 if you wish to continue the call." When I press 1, the other phone rings.
Could this be the result of the two units residing on the same LAN, or will this behavior persist when I move one of the OBi's to a second location? Or do I need to do something to get the OBi attendant out of the equation?
Thanks...