I got Obi200 recently, it works well with my cordless phone (including CallerID detection), but my voice modem (Hiro H50006; PCI card inside my Windows PC) doesn't work at all, when I connect the "Line" connector of the modem to the "Phone" connector of Obi200. I don't see any messages in the modem's log. (My Obi200 is using two VOIP providers, freephoneline and GV.)
Does anyone know if this can be fixed? I really need it to work, as the software I am running on PC (CallStation) is very good in zapping telemarketing calls. (It has ~40 numbers of telemarketers in its black list; every time one of them calls, it gets "this number is not in service" message). It worked fine when I had the land line.
Obi200 has dozens of options in Physical interfaces/Phone 1 section. I tried to play with some of them (like Impedance, different voltage settings), but still the modem's log is empty, and CallStation doesn't pick the call.
Perhaps I need to change my modem settings - like Port speed, Data protocol (Standard EC/Disabled/Forced EC), Compression (enabled/disabled), Flow control (Hardware/none), Data bits (4...8 ), Parity (None/even/odd/mark/space), or Stop bits (1,1.5,2)?