first of all, my obi100 stopped communicating to the dashboard. my dashboard says it's offline. when I checked the status, it says it doesn't have an ip address. I tried rebooting it and rebooting my router, with no success. I finally was able to set an ip manually and was able to configure it with google voice.
I added this:
<1AAA>[2-9]xxxxxxx
where AAA is my area code,
in the DigitMap but it still won't dial correctly.
when I check the call history, it is still dialing the 7 numbers I dialed. instead of the 1AAA plus the number I dialed to make a call.
am I missing something?
If you're configuring the OBi directly, make sure you have set:
System Management -> Auto Provisioning -> Auto Prvisioning -> Method : Disabled
If you're going to qualify the first digit ([2-9]), then you only want 6 additional digits (xxxxxx) -- you have 7.
Are you adding the 7-digit dialing rule to the proper DigitMap?
SP1/ITSPA : Service Providers -> ITSP Profile A -> General -> DigitMap : (<1aaa>[2-9]xxxxxx|...)
SP2/ITSPB : Service Providers -> ITSP Profile B -> General -> DigitMap : (<1aaa>[2-9]xxxxxx|...)
LINE Port : Physical Interfaces -> LINE Port -> DigitMap : (<1aaa>[2-9]xxxxxx|...)