Please forgive me for the basic question, i just got my device today.
I have two different Google Voice services setup (SP1 (default) & SP2). Inbound works great for both services, and outbound works for the first service since it is the default.
Question is, when I make an outbound call how can I select the 2nd service? I know i can make it default but i want to pick which line to use each time.
Thanks!
If sp1 is default, prepend **2 to the number you are dialing to send the call out on sp2.
**2 123 456 7890 for 10 digit dialing
**2 456 7890 for 7 digit dialing
I have mine set to give a second dial tone after dialing **2, then I dial the number normally.
for second dial tone:
Physical Interfaces -> PHONE Port -> DigitMap
default
([1-9]x?*(Mpli)|[1-9]|[1-9][0-9]|911|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|(Mpli))
edit for second dial tone
([1-9]x?*(Mpli)|[1-9]|[1-9][0-9]|911|**0|***|#|**1{t=di2}(Msp1)|**2{t=di2}(Msp2)|**8{t=od}(Mli)|**9{t=di2}(Mpp)|(Mpli))
Quote from: nockam on September 01, 2011, 11:43:47 PM
Question is, when I make an outbound call how can I select the 2nd service? I know i can make it default but i want to pick which line to use each time.
The default outbound trunk for calling is selected by:
Physical Interfaces -> PHONE Port -> PrimaryLine
An alternate trunk can be selected when dialing by using:
**1 + number -> SP1 Service
**2 + number -> SP2 Service
**8 + number -> PSTN Line
**9 + number -> OBiTALK Service
Thanks everyone this fully answered my question!
I am looking forward to learning more about what all I can do with this device and hopefully help contribute back to the community someday.
Hi guys,
I have OBI110, with a LINE Port (PSTN) Service, SIP 1 service, SIP 2 service.
I know how to select SIP1 or SIP2 at default call out, but how can I select LINE Port (PSTN) Service as on top of the default?
i.e.: I want to dial out directly by using PSTN, and
**1 for SIP1
**2 for SIP2
Thank you
kenhu2000ca,
Welcome
'#' key will give you the PSTN without the OBi doing any dial plan manipulation/verification, or select the PSTN as the primary line in your config. All call will automatically use PSTN in that case.
Physical Interfaces
PHONE Port->PrimaryLine = PSTN Line
Thank you!