Text only | Text with Images

OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: zrkd51 on May 01, 2019, 11:05:39 PM

Title: Obi110 restarts everytime I set up InboundCallRoute parameter.
Post by: zrkd51 on May 01, 2019, 11:05:39 PM
I'm trying to setup an Obi 110 with Asterisk, Outbound calls work very well, but whenever I try to setup the InboundCallRoute to SP2(XXXXXXXX), it would work for a couple of minutes and after that my gateway would restart, keeping the configuration but only reversing the InboundCallRoute parameter to its default.
Any idea on what could be going wrong?
Title: Re: Obi110 restarts everytime I set up InboundCallRoute parameter.
Post by: zapattack on May 01, 2019, 11:28:50 PM
Inbound call is XXXXXXXX
The Route is sp2, or :sp2
So the Inbound Call Route is {(XXXXXXXX):sp2}
P193 of the manual.
Title: Re: Obi110 restarts everytime I set up InboundCallRoute parameter.
Post by: drgeoff on May 02, 2019, 01:11:24 AM
Quote from: zrkd51 on May 01, 2019, 11:05:39 PM
I'm trying to setup an Obi 110 with Asterisk, Outbound calls work very well, but whenever I try to setup the InboundCallRoute to SP2(XXXXXXXX), it would work for a couple of minutes and after that my gateway would restart, keeping the configuration but only reversing the InboundCallRoute parameter to its default.
Any idea on what could be going wrong?
I'll guess that you are setting the InboundCallRoute using the 110's local web interface but have not disabled Obitalk provisioning. See the very top sticky post in this section of the forum.
Text only | Text with Images