Print Page - Firmware 1.3 : Some bugs

Title: Firmware 1.3 : Some bugs
Post by: Riyas on October 03, 2011, 06:30:19 AM

Hi,

My Obi110 was working perfectly. Yesterday, I've migrated to 1.3

Since then, i have some problems :

1) During callback, if I choose option 1, my phone port is not ringing. But my phone port stays busy. I have to reboot it manually (by unplugging power cord) to restore Obi.

2) It takes more than 30 to 40 sec to hang up a call placed or recieved through Line Port.

3 Spoof caller ID is not working for me. I don't know if my inbound call settings are good :

(009196008xxxxx):li1($1 > 062570xxxx)},{ph}

Thanks

Title: Re: Firmware 1.3 : Some bugs
Post by: OBT1677095 on October 24, 2011, 05:37:21 PM

Not sure if this is related or not, but since my upgrade to 1.3, my OBi 100, which is hung off of a D-Link DIR-615, requires a reboot every 24-36 hours else I'm unable to receive inbound calls (the caller receives a slow busy). If it matters, I use voip.ms.

Am open to suggestions.

OBiTALK Community

General Support => Day-to-Day Use => Topic started by: Riyas on October 03, 2011, 06:30:19 AM