Hi,
I'm trying to setup an OBI110 with my landline service. I want to be able to place calls from my mobile phone using my landline. I setup 2 SPs. SP1 is bridge to the Auto Attendant and SP2 goes directly to the phone port. When I call SP1, the call is bridged to the Auto Attendant but the audio is choppy. When I call SP2, the call goes directly to the phone and Audio is good. If I call from another OBI110 directly to the AA, audio is good.
I also want to eliminate or reduce the delay time when dialing from the phone connected to the OBI110. I belong to the dialing Zone 1, so I need that 10 digits and 1+10 digits phones dialed from the phone attached to the OBI110 to be dialed with no or minimum delay.
Regards
Try:
(8xxxxxxxxx|1xxxxxxxxxx|911|011xx.S5)
Removed "xx."
If a dialed number matches a rule, but can't match another rule with additional digits there will be no delay.
If a dialed number matches a rule, but CAN match another rule with additional digits there will be a 2 second delay.
Rule "xx." will match any number of digits, so you get the 2 second delay. Any delay beyond the 2 seconds is caused by your network or provider.
The AA shouldn't cause choppy audio. Temporarily remove the AA to see if the choppy audio disappears.