Text only | Text with Images

OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: home-with-gv on November 22, 2011, 02:08:55 PM

Title: how do I route international traffic from sp2?
Post by: home-with-gv on November 22, 2011, 02:08:55 PM
I have sp1 configured with google voice and SP2 to with  SIP account. I want to route my outbound international traffic from SP2 with out dialing **2 in the front. I want to have all the numbers prefixed with  011 shold go through SP2. Can somebody tell me how to do that? I really appreciate your response.
Title: Re: how do I route international traffic from sp2?
Post by: RonR on November 22, 2011, 02:37:58 PM
Service Providers -> ITSPA Profile A -> General -> DigitMap:

(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|<**2>011xx.|(Mipd)|[^*]@@.'@'@@.)


Service Providers -> ITSPA Profile B -> General -> DigitMap:

(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1aaa>[2-9]xxxxxx|011xx.|(Mipd)|[^*]@@.'@'@@.)


Physical Interfaces -> PHONE Port -> PrimaryLine : SP1 Service


where aaa is you local area code.
Title: Re: how do I route international traffic from sp2?
Post by: home-with-gv on November 22, 2011, 03:03:28 PM
Thanks a lot Ron for your quick response. It worked for one call but the device keeps on rebooting and going to default settings. And I am not able to see my changes. All I can see is default digitmap in both profiles. I was rebooting the device after the changes I made. that time I can see my changes. But some how the device reboots by itself and goes to defaults. can you guess what is going on here?
Title: Re: how do I route international traffic from sp2?
Post by: RonR on November 22, 2011, 03:22:36 PM
If you're configuring the OBi directly, also set:

System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
Title: Re: how do I route international traffic from sp2?
Post by: home-with-gv on November 22, 2011, 03:38:14 PM
yeap. I am configuring on Obi directly. it worked with the suggested changes.
Thanks a lot for quick and prompt response.
Title: Re: how do I route international traffic from sp2?
Post by: RonR on November 22, 2011, 03:42:29 PM
When configuring the OBi directly, you must disable Auto Provisioning or the OBiTALK Web Portal will repeatedly overwrite your changes with its settings.
Title: Re: how do I route international traffic from sp2?
Post by: obi-support2 on November 22, 2011, 10:01:05 PM
You should not disable provisioning; that is not the preferred method.
Please leave provisioning enabled.

Instead, the proper way is to use the OBi Expert Configuration on the OBiTALK device portal,
Enter OBi Expert, then find the corresponding parameter and
change it to your desired value (unchecking  OBiTALK settings and Device Default for that parameter also).

Making changes directly on the device web page should be your last resort, for example, in
the rare case that the parameter you want to change is not yet available in the
expert configuration page due to version differences.
Text only | Text with Images