I'm using Flowroute for E911. But when calls are made via them, my Flowroute username is used as the callerid. For E911 to work, they require the DID. Flowroute can use your DID as the username, as long as you can use the username in an authusername field. The OBI 110 doesn't seem to have this. So I basically need a authusername field on the OBI or a way to change the outbound callerid on the OBI.
Ideas?
Thanks
Voice Services -> SP1 Service -> AuthUserName
Voice Services -> SP2 Service -> AuthUserName
Thanks, but that's not enough. I need username AND auth username. They are different.
Quote from: Richard on November 25, 2011, 04:29:32 PM
Thanks, but that's not enough. I need username AND auth username. They are different.
Try putting your caller ID in SIP Credentials -> URI. I don't know whether for Flowroute you need to use 10 or 11 digits. Test by calling your cell phone or 1-800-437-7950.
After you get that working, test with 911. You should first get permission by calling your police non-emergency number. Call at a time when emergency traffic is not heavy. Immediately tell the dispatcher that you don't have an emergency and are just testing. Confirm that they have your correct number and physical address. Don't hang up until they have confirmed the non-emergency nature of your call, or the cops will likely show up at your door.
That appears to be working! But I'll try the 911 call tomorrow in the hopes that I can find a somewhat less busy time on the system. Thanks
Tested today and it worked great. E911 verified number and address correctly.