Print Page - Call bridge broken in 1.3

Title: Call bridge broken in 1.3
Post by: Salvatore on December 07, 2011, 12:36:58 PM

Hello all,

I upgraded to 1.3.0(2651) but I am still having troubles bridging calls.
Incoming calls come in via SIP. I am trying to bridge incoming calls to:

a. ph (connected analog phone line) - no voice at all.
b. SP1 (dial out using SIP) - two way voice.
c. li (connected line to telco/pbx) - no voice.

With 1.2.x, all three of above scenarios working fine. Is it possible to get the firmware image for 1.2 so we can downgrade?

Is there any other alternate solution?

Title: Re: Call bridge broken in 1.3
Post by: RonR on December 07, 2011, 12:45:45 PM

Quote from: Salvatore on December 07, 2011, 12:36:58 PM
Is it possible to get the firmware image for 1.2 so we can downgrade?

Although I've never tried it to see what would happen, Obihai claims it's not possible to downgrade an OBi below v1.3 once it's been upgraded to v1.3.

OBiTALK Community

General Support => Day-to-Day Use => Topic started by: Salvatore on December 07, 2011, 12:36:58 PM