Text only | Text with Images

OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: einfostar on December 13, 2011, 10:55:14 AM

Title: Can't modify digitMap
Post by: einfostar on December 13, 2011, 10:55:14 AM
I am trying to modify the DigitMap of ITSP Profile A.  After I make changes, and reboot, the changes take into effect briefly, and then it will fall back to its original value.  Any clue what is wrong?
Title: Re: Can't modify digitMap
Post by: RonR on December 13, 2011, 11:13:27 AM
You must disable Auto Provisioning or the OBiTALK Web Portal will keep forcing the OBi back to its settings:

System Management -> Auto Provisioning -> ITSP Provisioning -> Method : Disabled
System Management -> Auto Provisioning -> OBiTALK Provisioning -> Method : Disabled
Title: Re: Can't modify digitMap
Post by: einfostar on December 13, 2011, 11:20:14 AM
Cool.  Thanks.
Title: Re: Can't modify digitMap
Post by: Felix on December 13, 2011, 11:24:19 AM
Hold on... What RonR says is correct assuming you do that on the device itself. However, I find it more convenient to maintain almost settings from "Expert mode" on the web. In such case, you obviously don't want to disable provisioning!
The result is the same... Digit map settings should stick!
Text only | Text with Images