Hello,
I recently bought a second unit (Obi100) to connect to a second router in a different location than my first unit.
After plugging the unit to the router, I can make the test call to **9 222 222 222. However, the internet stop working after that, and the OBi and the computer connected to the same router cannot connect to the Internet any more.
I can only connect to the internet after rebooting the router without the OBi coonnected to it.
Any help would be greatly appreciated!
Thanks a lot!!
It's a total shot in the dark, but you might try changing the OBi Ethernet port from 10mbs/half-duplex to 100mbs/full-duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
How can you tell if your OBi setup is operating at 10mbs/half-duplex vs 100mbs/full-duplex?
Quote from: RonR on December 28, 2011, 09:17:46 PM
It's a total shot in the dark, but you might try changing the OBi Ethernet port from 10mbs/half-duplex to 100mbs/full-duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
Quote from: Diana on December 29, 2011, 03:38:08 AM
How can you tell if your OBi setup is operating at 10mbs/half-duplex vs 100mbs/full-duplex?
The default is 10mbs/half-duplex.
***0/option 27 reports the current value before allowing you to change it:
0 = 10mbs/half-duplex
1 = 100mbs/full-duplex