I am trying to set PSTN as the default but it always comes back SP1 as default after the reboot.
My setup SP1 is GV and LINE port is Vonage. I would like to use LINE for all my incoming and outgoing calls. I also don't want to type # for outgoing calls. Is it possible?
I went to Physical Interfaces -> PHONE Port -> Primary Line - PSTN Line. Then clicked submit. Then clicked the reboot.
Then refreshed the browser it comes back SP1 Service for primary line. How do I correct it?
I updated the latest firmware.
try it from the portal.
At your dashboard select your obi
choose SP1
uncheck "Make This the Primary Line to Call Out "
submit
That should put it back to default which is PSTN.
Reset to default. System Management/Device Update/Reset Configuration.
That was the only way I could figure it out.
Thank you jimates & tbaggot. Jimates way worked out for me.
Hi Rangav,
I'm trying to setup something similiar to yours. And experience a 9-10 seconds delay after entering all the digits before getting a ring. Wondering if you have any delay on yours?