Any chance of being able to route calls matching particular patterns to various providers (and/or the line port, etc.) when using the OBiTALK portal for device configuration? Would like to be able to specify certain patterns go out SP1 (and if that fails then SP2) while others (particularly three digit extensions, in a case where SP2 is an extension on an Asterisk server) go directly to SP2. I understand this can be done if you manually configure the device, but it would be great if it could be done from the portal, which might also allow configuration in a slightly more user-friendly format that could then be translated to the strings that the OBi110 needs.
Quote from: MichiganTelephone on January 26, 2011, 02:53:27 PM
Any chance of being able to route calls matching particular patterns to various providers (and/or the line port, etc.) when using the OBiTALK portal for device configuration? Would like to be able to specify certain patterns go out SP1 (and if that fails then SP2) while others (particularly three digit extensions, in a case where SP2 is an extension on an Asterisk server) go directly to SP2. I understand this can be done if you manually configure the device, but it would be great if it could be done from the portal, which might also allow configuration in a slightly more user-friendly format that could then be translated to the strings that the OBi110 needs.
I second this. In fact, I would like to see both the DigitMap and routing settings available via the OBiTALK portal, perhaps in an advanced settings section.