Print Page - Configuring Asterisk 1.9 through Diginum GUI and the OBi110

Title: Configuring Asterisk 1.9 through Diginum GUI and the OBi110
Post by: ygator on November 02, 2013, 06:54:09 PM

I was able to get my OBi110 working with my old trixbox setup. However, now I want to migrate my pbx over to Asterisk running on a Synology Diskstation. The Diskstation is running Asterisk 1.8.13.1 with GUI-version 2.1.0-rc1.

I have tried many times and just can't get it to work. When I setup a trunk which I thought was the correct way I get an error in the Asterisk log that says:
NOTICE[14621] chan_sip.c: Registration from '<sip:OBITRUNK1@DiskstationIP>' failed for 'OBi110IP:5061' - No matching peer found

I just can't figure out how to translate the freepbx setup to the Asterisk GUI setup.

I'd like to be able to have incoming/outgoing calls on the FXO, plus use the FXS as an extension on Asterisk, and be able to receive and make calls on Google Voice.

Can anyone help?

Thanks.

Title: Re: Configuring Asterisk 1.9 through Diginum GUI and the OBi110
Post by: ygator on November 16, 2013, 10:47:23 AM

Can anyone help??? I would really like to get this up and running so I can retire my old Trixbox setup.

Title: Re: Configuring Asterisk 1.9 through Diginum GUI and the OBi110
Post by: Lavarock7 on November 16, 2013, 03:23:09 PM

:)Looking for that error I found this. It may help

http://www.freepbx.org/forum/freepbx/general-help/no-matching-peer-found-while-registration-freepbx-asterisk

http://www.freepbx.org/forum/freepbx/users/pap2t-no-matching-peer-found

Title: Re: Configuring Asterisk 1.9 through Diginum GUI and the OBi110
Post by: ygator on November 18, 2013, 12:12:59 PM

Thanks for the reply. I'll check it out.

OBiTALK Community

General Support => Installation and Set-Up (Devices) => Topic started by: ygator on November 02, 2013, 06:54:09 PM