Is there any way to add a notation to a speed dial on the obi? For instance if I were to write a program I would use something like the following.
#This is what the program does.
Or
//This function does this.
Not what you are looking for, but I went to the web page that sets up the speed dials. From there I am hazy on what I did... I may have used a text editor macro on the HTML source, or I might have printed to a PDF file and copied stuff.
Anyway, I printed a piece of paper with the dial digits and description.
@giqcass
That sounds like a good feature request. The ability to add a short description to the speed dials.
Quote from: Shale on December 18, 2013, 09:05:25 PM
Not what you are looking for, but I went to the web page that sets up the speed dials. From there I am hazy on what I did... I may have used a text editor macro on the HTML source, or I might have printed to a PDF file and copied stuff.
Anyway, I printed a piece of paper with the dial digits and description.
With the rate at which I change some of them to experiment I better use a dry erase board. ;)